Analytical-industries GPR-1000 ATEX Portable Trace PPM Oxygen Analyzer Manuel d'utilisateur télécharger pdf (Page 13)

Establishing Power to the Electronics:

Establish power to the analyzer electronics by pushing the red ON/OFF key. The digital display responds

instantaneously. When power is applied, the analyzer performs several diagnostic system status checks termed

“START-UP TEST” as illustrated below:

START-UP TEST

ELECTRONICS – PASS

BATTERY – PASS

TEMP SENSOR – PASS

BARO – N/A

REV. 1.37

In the unlikely event the LED warning indicator LOW BATT comes on when the analyzer is turned on – proceed

immediately to the sub-section on Battery Considerations at the end of section 5 Operation.

Note: The analyzer display defaults to the sampling mode when 30 seconds elapses without user interface.

00.00 PPM

AUTO SAMPLING

10 PPM RANGE

24.5 C

Menu Navigation:

The five (5) pushbuttons located on the front of the analyzer operate the

micro-processor:

1. green ENTER (select)

2. yellow UP ARROW

3. yellow DOWN ARROW

4. blue MENU (escape)

5. red ON/OFF

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 30 31

Pas de commentaire

Analytical-industries GPR-1000 ATEX Portable Trace PPM Oxygen Analyzer Manuel d'utilisateur Page 13