Analytical-industries GPR-1100 ATEX Portable Trace PPM Oxygen Analyzer Manuel d'utilisateur télécharger pdf (Page 35)

Incompatibility Avoid contact with strong bases

Hazardous Decomposition Products Emits toxic fumes when heated

Conditions to Avoid Heat

Spill or Leak

Steps if material is released Sensor is packaged in a sealed protective plastic bag, check the sensor inside for electrolyte

leakage. If the sensor leaks inside the protective plastic bag or inside an analyzer sensor housing

do not remove it without rubber or latex gloves, safety glasses and a source of water. Flush or

wipe all surfaces repeatedly with water or wet paper towel. Use a fresh towel each time.

Waste Disposal Method In accordance with federal, state and local regulations for battery disposal.

Health Hazard Information

Primary Route(s) of Entry Ingestion, eye and skin contact

Exposure Limits Acetic Acid - ACGIH TLV / OSHA PEL 10 ppm (TWA); Lead - OSHA PEL .05 mg/cubic meter

Effects of Exposure -

Ingestion Electrolyte could be harmful or fatal if swallowed; Oral LD50 (RAT) = 6620 mg/kg

Eye Electrolyte is corrosive and eye contact could result in permanent loss of vision.

Skin Electrolyte is corrosive and skin contact could result in a chemical burn.

Inhalation Liquid inhalation is unlikely.

Symptoms Eye contact - burning sensation; Skin contact - burning sensation.

Medical Conditions Aggravated None

Carcinogenic Reference Data NTP Annual Report on Carcinogens - not listed; LARC Monographs - not listed; OSHA - not listed

Other Lead is listed as a chemical known to the State of California to cause birth defects or other

reproductive harm. Lead acetate formed as the sensor is used is listed as a chemical known to

the State of California to cause cancer.

Emergency First Aid

Ingestion Do not induce vomiting; Give plenty of cold water or if available milk; Seek medical attention

immediately.

Skin Contact Wash affected area repeatedly with plenty of water; Remove contaminated clothing; If burning

persists, seek medical attention.

Eye Contact Flush repeatedly with plenty of water for at least 15 minutes; Seek medical attention

immediately.

Inhalation Liquid inhalation is unlikely.

Special Protection Information

Ventilation Requirements None

Eye Safety glasses

Hand Rubber or latex gloves

Respirator Type Not applicable

Other Protective Equipment None

Special Precautions

Precautions Do not remove the sensor’s protective Teflon and PCB coverings; Do not probe the sensor with

sharp objects; Wash hands thoroughly after handling; Avoid contact with eyes, skin and clothing;

Empty sensor body may contain hazardous residue.

Transportation Not applicable

1 2 ... 30 31 32 33 34 35

Pas de commentaire

Analytical-industries GPR-1100 ATEX Portable Trace PPM Oxygen Analyzer Manuel d'utilisateur Page 35